You can insert the wire in an existing expansion joint or you can cut a slot with a circular saw that has a masonry blade.
Electric dog fence installation driveway.
This is the most important step.
It should take about an hour for the 1 st and 2 nd steps.
Crossing the driveway will take about an hour.
Using high tech pet ultra wire will give you and improved underground fence installation compared to typical electric dog fence wire.
The driveway is often a major obstacle for diy underground dog fence installations.
Push the dog fence wire down into the holes on both ends of the pathway.
A transmitter plugs into a standard outlet and emits a signal that travels along underground wires.
Make sure the dog fence wire is laying in the bottom of the groove and not sticking out.
Use a hand shovel to dig a 10 12 inch hole on each end of the groove where the driveway meets the grass.
Place the wire in the trench and fill.
You will spend about 4 hours to bury the wire if you use a trencher or edger.
You may also choose to tunnel underneath the driveway.
Secure the wire to the bottom of both holes using dog fence staples.
Inserting the wire in an expansion crack is the most common because it is easy and the wire is hidden.
A hidden boundary is created and a receiver on your dog s collar sounds a warning tone when the dog wanders near the boundary.
Be sure to take the time to plan carefully.
It is a good idea to set aside about 10 hours to get your installation completed.
Often the solution is easy.