Just grab the carpet with pliers and pull.
Easy way to remove carpet tack strips.
Repeat until the tack strip is completely removed and discard safely in a trash receptacle so no one is injured.
Continue pulling up carpet a few feet at a time and cutting it into easy to handle strips.
Oh and do be careful when removing carpet tack strips.
To easily remove the carpet tack strip move the pry bar near a nail and pry up while gently lifting the end of the tack strip with your other hand.
Hook a crowbar into the slit and pull the corner of the carpet off.
Continue like this until you have freed the entire strip.
A very easy way to remove carpet tack strip from the basement concrete floor.
Then grab the carpet by hand and continue to pull it up along an entire wall.
Slide the pry bar down to the next nail and repeat until the strip is loose from the floor.
Those tacks are beyond sharp.
If you are pulling up carpet from stairs.
Roll up the strips and tape them for easy handling.
Carpet tack strips can usually remain in place but look for rust rot or other damage.
Begin at the top of the stairs.
Press the pry bar in order to begin lifting the tack strip.
Reinsert them beside the next nail on the tack strip and pop that nail out the same way.
Discard the old tack strip in a heavy duty trash.
You are likely to find that the tack strip is nailed to the floor about every 6 inches.
Cut a slit in the carpet about 6 inches away from a corner using a carpet knife which is a utility knife with a curved blade.
Joe is working on a carpet removal project now he is ready to.
Its not that hard with these tips from clay king from aaa flood drying with 28.
Once the carpet is removed locate the nails which attach the tack strips to the floor.
Positioning the pry bar at each nail and lifting upward will loosen it from the floor for easy removal.
Roll or fold the strip secure with duct tape and remove it from the room.
Then tap it with a hammer until the tack strip pops up.