Carefully pry up a corner top or bottom and yank with intermittent pulls.
Easiest way to remove carpet staples.
How to replace carpet.
Remove carpet step 3.
Most will find it easiest to start pulling from a corner.
Slide the tip of the heavy duty office stapler under the carpet staple.
Simply unscrew the clamps at the juncture of horizontal and vertical and place the rod assembly in a safe place.
Press down the handle to pop the staple out of the wood.
Removing carpet runners that have bar rods and floor clamps is much easier although you might need to remove adhesive as part of the process.
Step 2 start pulling the carpet.
The first thing you need to do is figure out how many strips you ll need to cut.
In that case use the pliers to fully remove the staple.
Respirators masks step 1.
You can use your 6 in 1.
Step 3 roll up the carpet.
Leave transitions for the installer.
The ordinary cat s paw is one of the most common ways to deal with staples in reclaimed lumber.
Flooring installers don t use a cat s paw to remove staples after old carpet has been removed.
Apply leverage with the angled tip to pop the staples out.
How does it work.
The best way to remove staples from wood lumber and the cat s paw.
Step 1 cut the carpet into strips.
Cut the carpet where necessary to remove large strips of carpet at once.
Depends on the staples used.
Make preparations step 2.
If your carpet is wrapped around the balusters it is probably cut in a place similar to the pink lines below.
Sometimes one end of the staple may still be stuck in the wood.
Fold the carpet over for easy cutting and slice it into narrow strips.
Slowly scrape the staple liking you are trying to skim off a thin layer of dirt.
Pull cut and roll.
Roll up the strips and tape them for easy handling.
Spade end just did this today worked great.